To Next PageTo Next PageWhy is my Mitsubishi Electric Heat Pump emitting white mist?
A white mist or vapor from your Mitsubishi Electric Heat Pump's indoor unit can occur when the indoor temperature and humidity are high, especially when operation starts. Also, during defrosting mode, cool airflow may blow down and appear like a mist.
Why does my Mitsubishi Electric TRANE TPKA0A 1HA70 turn on by itself?
If your Mitsubishi Electric Heat Pump starts operating without pressing the ON/OFF button, check if the on timer is set and, if so, press the ON/OFF button to stop it. If the air conditioner is connected to a central wired remote controller or if “ ” appears in the wired remote controller display, consult the relevant people who control the air conditioner. Also, check if the auto recovery feature from power failures has been set and, if so, press the ON/OFF button to stop operation.
Why is my Mitsubishi Electric Heat Pump remote not working?
If nothing appears on your Mitsubishi Electric Heat Pump's IR wireless remote controller display, the display is faint, or the indoor unit doesn't receive signals unless the remote is close, the batteries are likely low. Replace the batteries and press the Reset button. If nothing appears even after replacing the batteries, ensure they are installed correctly (+, –).
Why isn't my Mitsubishi Electric TRANE TPKA0A 1HA70 blowing warm air immediately?
Warm air will not blow from your Mitsubishi Electric Heat Pump until the indoor unit has sufficiently warmed up.
Why won't my Mitsubishi Electric TRANE TPKA0A 1HA70 Heat Pump turn back on right away?
If your Mitsubishi Electric Heat Pump doesn't restart immediately after being turned off, even when pressing the ON/OFF button, wait approximately 3 minutes. The unit may have stopped to protect itself.
Why does my Mitsubishi Electric TRANE TPKA0A 1HA70 Heat Pump keep turning off?
If your Mitsubishi Electric Heat Pump stops on its own, verify if the off timer is active and, if so, press the ON/OFF button to restart it. If the unit is connected to a central wired remote controller or if “ ” appears in the wired remote controller display, consult the relevant people who control the air conditioner.
What to do if an error code appears on my Mitsubishi Electric TRANE TPKA0A 1HA70 remote?
If an error code appears on your Mitsubishi Electric Heat Pump's remote controller, it indicates that the protection devices have been activated. Do not attempt to repair the equipment yourself. Immediately turn off the power and consult your dealer, providing the model name and the error code displayed.
General| Brand | Mitsubishi Electric |
|---|---|
| Model | TRANE TPKA0A 1HA70 |
| Category | Heat Pump |
| Language | English |
