To Next PageTo Next Page
Need help?Do you have a question about the Mitsubishi Heavy Industries FDENA151 and is the answer not in the manual?
General| Brand | Mitsubishi Heavy Industries |
|---|---|
| Model | FDENA151 |
| Category | Air Conditioner |
| Language | English |
Lists technical specifications for indoor units, including cooling/heating capacity, power, and dimensions.
Explains the installation procedure, mounting dimensions, and wiring for the wired remote controller.
Details the refrigerant piping layout for twin type outdoor and indoor units.
Shows the refrigerant piping configuration for triple type outdoor and indoor units.
Illustrates the refrigerant piping layout for double twin type systems.
Details how temperature affects cooling and heating capacity coefficients.
Presents noise level charts for FDTA series indoor units at various frequencies and fan speeds.
Shows the wiring diagram and component details for indoor units.
Presents the wiring diagram and component details for outdoor units.
Details the functions and displays of the wired and wireless remote controllers.
Details the protection mechanism against heating overload based on indoor heat exchanger temperature.
Specifies the criteria that trigger the defrosting operation.
Explains the protection measures against compressor overcurrent and abnormal stops.
Details high pressure control logic for heating, cooling, and abnormal conditions.
Describes the low pressure detection and abnormal stop conditions for specific models.
Highlights essential safety warnings and cautions for installation and operation.
Guides on choosing optimal locations for indoor units, considering air flow and drainage.
Provides instructions for drain piping installation, including slope and material requirements.
Guides on choosing optimal locations for remote controllers, avoiding interference.
Details the steps for installing wired and wireless remote controllers.
Provides specific instructions and cautions for drain piping installation.
Guides on choosing optimal installation locations for FDUR units.
Provides instructions and cautions for drain piping installation on FDUR units.
Covers accessories, location selection, and minimum installation space.
Details the steps and precautions for conducting an air tightness test.
Explains the process of purging air from the refrigerant system.
Provides essential servicing procedures for the air conditioning system.
Details the evacuation procedure using a vacuum pump to remove impurities.
Explains the process of charging refrigerant into the system.
Provides guidance on diagnosing and resolving issues within the refrigerant circuit.
Offers methods to judge operating conditions by comparing pressure and temperature differences.
Guides on diagnosing issues using error codes and indicator lights.
A table that correlates error codes and LED indications with potential causes.
Provides a flowchart for diagnosing errors based on displayed codes and symptoms.
Describes the gas low error condition specific to FDCA801/1001 models.
