To Next PageTo Next Page
Need help?Do you have a question about the Mitsubishi Heavy Industries SRC25ZJX-SA and is the answer not in the manual?
General| Brand | Mitsubishi Heavy Industries |
|---|---|
| Model | SRC25ZJX-SA |
| Category | Air Conditioner |
| Language | English |
Technical specs for SRK25ZJ-S indoor and SRC25ZJ-SA outdoor units.
Technical specs for SRK35ZJ-S indoor and SRC35ZJ-SA outdoor units.
Technical specs for SRK20ZJX-S indoor and SRC20ZJX-SA outdoor units.
Technical specs for SRK25ZJX-S indoor and SRC25ZJX-SA outdoor units.
Technical specs for SRK35ZJX-S indoor and SRC35ZJX-SA outdoor units.
Dimensional drawings and measurements for various indoor units.
Dimensional drawings and measurements for various outdoor units.
Dimensions for both wireless and wired remote controllers.
Electrical schematic for indoor units, showing component connections.
Electrical schematic for outdoor units, showing power source and component connections.
Illustrates the refrigerant flow and components for cooling and heating cycles.
Instructions for drain piping, including grommets and elbow usage.
Noise level graphs for various indoor and outdoor units.
Tables showing cooling and heating capacity based on temperatures and airflow.
Details operational limits for temperature, piping length, voltage, and ON/OFF cycles.
Provides correction factors to adjust cooling and heating capacity based on temperatures.
Safety precautions, installation space, tools, and step-by-step procedures for indoor unit setup.
Safety precautions, installation location, and steps for installing the outdoor unit.
Details restrictions, pipe sizing, wall thickness, and on-site piping work, including flaring.
Details electrical wiring requirements, cable types, grounding, and circuit breakers.
Explains the functions and buttons of the remote controller for SRK25/35ZJ-S models.
Explains the functions and buttons of the remote controller for SRK20-35ZJX-S models.
Details the use of the unit's ON/OFF button and the auto restart function.
Instructions for modifying circuit boards to prevent signal conflicts with multiple remotes.
How to adjust flap and louver direction and swing using the remote controller.
Explanation of the 3D auto operation mode for optimized airflow and conditioning.
Details on setting ON timer, SLEEP timer, and OFF timer functions.
How to set the indoor unit's installation location for optimal airflow direction.
Explains major components and control details during heating operation.
Explains major components and control details during cooling operation.
How the unit determines operation mode based on temperatures.
Protective measures related to sensors, cooling high pressure, and heating high pressure.
Protection against overload, low temperatures, compressor issues, and system errors.
Protection for fan motors, refrigeration cycle, and defrost heater control.
Instructions for installing the wired remote controller, including wiring and settings.
Details on connecting and installing the SC-BIKN-E interface kit.
Instructions for applying and controlling the Super Link E board.
Important safety notes and initial checks before troubleshooting maintenance tasks.
Step-by-step guide for diagnosing issues when the unit does not operate at all.
Diagnostic flow chart for troubleshooting when the air conditioner is running but malfunctioning.
Table correlating display/flashing conditions with causes and error codes for self-diagnosis.
Explains how to enter service mode and interpret service/stop data for diagnostics.
Guides through checking sensor errors, fan motor errors, current cut, and safe stop issues.
Procedures for diagnosing problems related to the outdoor unit, fan motor, and compressor.
Describes phenomena observed due to short circuits or wire breakages in sensors.
Procedures for checking the indoor PCB and fan motor resistance.
Guides on how to check if the wireless remote controller is functioning correctly.
Highlights key inspection points on the outdoor unit and relevant checks.
