To Next PageTo Next PageWhat to do if my Mitsubishi Heavy Industries SRK35ZMXA-S is not cooling or heating properly?
If your Mitsubishi Heavy Industries Air Conditioner isn't cooling or heating well, check the thermostat setting to ensure it's at a suitable temperature. Also, verify that the air filter is clean and not clogged. Finally, make sure all doors and windows are closed.
What to do if my Mitsubishi Heavy Industries SRK35ZMXA-S is not cooling well?
If your Mitsubishi Heavy Industries Air Conditioner isn't cooling effectively, check if direct sunlight is entering the room. Also, see if there is a heat source present in the room. Finally, consider whether there are too many people in the room.
What to do if my Mitsubishi Heavy Industries SRK35ZMXA-S Air Conditioner unit does not restart immediately after stopping?
Please wait for three minutes before restarting your Mitsubishi Heavy Industries Air Conditioner. The RUN light will remain on during this period.
What to do if my Mitsubishi Heavy Industries Air Conditioner doesn't restart after a power cut?
Use the remote control to start the operation again.
What to do if remote control signals are not received by my Mitsubishi Heavy Industries SRK35ZMXA-S?
Reduce direct sunlight or other strong light sources that might be interfering with the remote control signal.
What to do if my Mitsubishi Heavy Industries SRK35ZMXA-S does not work at all?
If your Mitsubishi Heavy Industries Air Conditioner isn't working, make sure the power switch is turned on. Also, check if the timer has been set to the “ON” position. Finally, check for a power failure or a blown fuse.
Why does my Mitsubishi Heavy Industries SRK35ZMXA-S fan not stop immediately after stopping operation?
The indoor fan may continue to run for up to 2 hours if the CLEAN operation is set. The outdoor fan may continue to run for about a minute to protect the unit.
Why is there no airflow when starting the HEATING operation on my Mitsubishi Heavy Industries SRK35ZMXA-S?
Airflow is intentionally stopped to prevent cold air from blowing out until the indoor heat exchanger has warmed up, which usually takes 2 to 5 minutes. This is part of the HOT KEEP program.
Why is there no airflow when starting the DRY operation on my Mitsubishi Heavy Industries Air Conditioner?
The indoor fan may stop to prevent re-evaporation of dehumidified moisture and to save energy.
Why does the RUN light stay on even after I've stopped my Mitsubishi Heavy Industries SRK35ZMXA-S Air Conditioner?
The RUN light illuminates during CLEAN operation and turns off when CLEAN operation ends.
General| Type | Split System |
|---|---|
| Cooling Capacity | 3.5 kW |
| Heating Capacity | 4.0 kW |
| Energy Efficiency Ratio (EER) | 3.21 |
| Power Supply | 220-240V, 50Hz |
| Refrigerant | R32 |
| Indoor Unit Weight | 9 kg |
Covers warnings and cautions for safe installation of the air conditioner unit.
Details safety measures and prohibitions during air conditioner operation.
Safety guidelines for moving or repairing the air conditioner unit.
Steps to select COOL, HEAT, DRY, or FAN modes and set temperature.
How to program daily ON/OFF operations for the week.
Detailed steps for setting individual timer programs for each day.
How to set the same program across all days of the week.
Procedures to cancel individual or collective weekly timer settings.
How to set night setback for comfortable night temperature and silent operation.
Step-by-step guide to removing, cleaning, and reinstalling air filters.
Checks to perform before calling a service technician for malfunctions.
Situations requiring immediate dealer contact due to abnormalities.
Interpreting error codes indicated by flashing lights on the unit.
