1. Park your vehicle in a safe place and turn the ignition switch to
LOCK position.
2. Connect the cable
(cable is not included with the vehicle) to the
USB memory device
or the Dock connector
to the iPod
.
3. Open the cover
in the floor console box. Connect the cable to
the USB input terminal
.
4. Turn the ignition switch to the “ACC” position. Turn on the audio
system.
5. Press E several times to switch to the USB mode. The input mode
changes as follows:
CD
USB
Bluetooth
®
(if equipped)
6. Depending on your USB device, it may take longer for playback to
start.
7. Once the device is selected, playback starts.
With Display Audio System, follow steps 1 through 4 above
5. Press MENU on the touch screen.
6. Touch USB.
7. Touch <Folder> then select a track and begin playback.
10
AUDIO SYSTEM
NOTE: Please refer to your Owner’s Manual for more detailed information on
how to use your audio system.
USB and iPod Input (if equipped)
Audio Remote
Control Button
(if equipped)
VOLUME
UP
VOLUME
Down
SEEK
Change
station or
track
MODE
Change the
audio source
C
D
B
E
A
To enter frequencies into the memory (AM/FM/SAT)
1. Press A to turn on the audio system.
2. Press B to select the desired band (AM/FM/SAT).
3. Press C to Seek Station
4. Hold down one of the Memory select buttons D (1-6) until it
beeps in order to save that station to memory.
To Next Page
Loading...
Need help?
General
