STARTING AND DRIVING
5–35
Driving hints
(1) TCL does not actively apply brakes. Al-
ways decelerate the vehicle sufficiently
before entering corners or bends.
(2) On snowy or icy roads, drive slowly
using tyre chains or snow tyres.
(3) When the TCL indication lamp illumi-
nates, SLIP control is being operated,
and it means that the road is slippery or
your vehicle is excessively accelerating.
In this situation, release foot from the ac-
celerator pedal and maintain moderate
speed.
(4) Never mix or use tyres of different size
since the TCL system could function in-
correctly and make safe driving difficult.
I26A127a
Indication lamp
1. When the ignition switch is turned
“ON”, the TCL indication lamp illumi-
nates and goes out after a few sec-
onds.
2. When SLIP control is exerted while
driving, the TCL indication lamp will il-
luminate.
CAUTION
(1) If the TCL indication lamp stays
on or does not illuminate when
the ignition switch is turned
”ON”, it indicates that any mal-
function may occur in the system.
(2) If the TCL indication lamp flashes
when you drive the vehicle, it indi-
cates that any malfunction oc-
curs in the system.
When either (1) or (2) happens,
have your vehicle checked at an
authorized MITSUBISHI dealer.
To Next Page
Loading...
