LOCKING AND UNLOCKING
2–3
F11C003g
NOTE
(1)In the following cases the vehicle may
not be able to receive the registered ID
code from the key. This means the en-
gine will not start even when the regis-
tered key is turned to the “START”
position.
D When the key contacts a key ring
or other metallic or magnetic object
(Type A)
D When the key grip contacts metal
of another key (Type B)
D When the key contacts another
immobilizing key, or some other
transponder (Type C)
In cases like these, remove the object
or additional key from the vehicle key
and turn the key back to the “ACC” or
“LOCK” position. Then try again to
start the engine.
If the engine does not start, consult an
authorized MITSUBISHI dealer.
(2) Be careful not to damage the key with a
cutter etc. since there is a transponder
inside the key.
(3) Two keys are provided.
If you lose one of them, order a key from
your authorized MITSUBISHI dealer as
soon as possible.
To o b t a i n a key, take your vehicle and
any remaining keys to your authorized
MITSUBISHI dealer.
If you need an extra spare key, take
your vehicle and ALL the keys to your
authorized MITSUBISHI dealer. Be-
cause all the keys have to be re-regis-
tered in the immobilizer computer unit.
The immobilizer allows up to 8 different
ID codes to be registered; you can pos-
sess a maximum of 8 keys.
CAUTION
Don’t make any alterations or addi-
tions to the immobilizer system; any
alterations or additions could cause
failure of the immobilizer.
To Next Page
Loading...
Need help?
General
