VEHICLE CARE
7–6
Servicing of plastic parts
EK29AMEc
Use a sponge or chamois leather.
If a car wax adheres on a grey or black rough
surface of the bumper, moulding or lamps,
the surface becomes white. In such a case,
wipe it off using lukewarm water and soft
cloth or chamois leather.
CAUTION
(1) Do not use a scrubbing brush or
other hard tools as they may dam-
age the plastic part surface.
(2) Do not use wax containing com-
pound (polishing powder) which
may damage the plastic part sur-
face.
(3) Do not bring the plastic parts into
contact with brake fluids, engine
oils, greases, paint thinners,
painting, and sulphuric acid (bat-
tery electrolyte) which may stain,
or discolour the plastic parts.
If they touch the plastic part, wipe
them off with soft cloth, chamois
or the like and an aqueous sol-
ution of neutral detergent, then
immediately rinse the affected
parts with water.
Aluminium wheels*
EK35A-Af
A protective coating is provided over the alu-
minium type wheels.
Clean aluminium wheels with a cleaner de-
signed for use on aluminium and apply an
appropriate protection agent.
NOTE
(1) When cleaning aluminium type wheels,
do not use abrasive cleaners. Wheels
exposed to sea water or road chemicals
should be cleaned as soon as possible.
(2) Brushes may damage the aluminium
wheel surface. Always use a sponge,
chamois leather, etc.
(3) Do not apply hot water directly from the
steam cleaner or similar to the wheel
surface.
Window glass
EK10A-Ca
The window glass can normally be cleaned
using only a sponge and water.
Glass cleaner can be used to remove oil,
grease, dead insects, etc. After washing the
glass, wipe dry with a clean, dry, soft cloth.
Never use the same cloth to wipe the win-
dow glass as would be used to wipe the
paintwork; wax from the painted surfaces
could adhere to the glass and reduce its
transparency and visibility.
NOTE
To clean the inside of the rear window, al-
ways use a soft cloth and wipe the window
glass along the demister heater element so
as not to cause damage.
Wiper blades
EK11A-Aa
Use a soft cloth and glass cleaner to remove
grease, dead insects, etc., from the wiper
blades. Replace the wiper blades when they
no longer wipe properly. (Refer to
page 9–18)
To Next Page
Loading...
