SEATS AND SEATBELTS
3–19
G18C021a
Installing a child restraint system
to a 3-point type seat belt
(with emergency/automatic lock-
ing mechanism)
EG20D-A
The 3-point type seat belts at the seat posi-
tions above can be converted from normal
emergency locking retractor (ELR) mode to
automatic locking retractor (ALR) mode. It
must be so converted, when installing a child
restraint system.
G18C054a
Installation:
1. Place the child restraint system in the
rear seating position as shown in the
illustration.
2. Route the belt through the child re-
straint according to the child restraint
system manufacturer’s instructions,
then insert the latch plate into the
buckle.
G18C055a
3. To activate the ALR mode, slowly pull
the shoulder part of the belt all the way
out until it stops, then let the belt feed
back into the retractor.
4. After the belt has retracted, tug on it. If
the belt is locked, you will not be able
to pull it out. If you can pull the belt out,
it is not locked and you will need to re-
peat these steps.
To Next Page
Loading...
