GENERAL INFORMATION
1–9
Modification / alterations to
the electric or fuel systems
EB11A-D
MITSUBISHI has always manufactured
safe, high quality vehicles. In order to main-
tain this safety and quality, it is important that
any accessory that is to be fitted, or any
modifications carried out which involve the
electric or fuel systems, should be carried
out in accordance with MITSUBISHI guide-
lines.
CAUTION
Please consult an authorized MITSU-
BISHI dealer concerning any such fit-
ment or modification.
If the wires interfere with the vehicle
body or improper installation
methods are used (protective fuses
not included, etc.), electronic devices
may be adversely affected, resulting
in a fire or other accident.
B10A001a
Roof drip moulding
EB10A-T
When installing the roof carrier, remove the
roof drip moulding caps.
1. Open the cover (A) and remove the
screws using a Philips screwdriver.
2. Remove the caps by sliding them.
After removal of the roof carrier, replace the
roof drip moulding caps.
Roof carrier precaution
EB10A-U
CAUTION
(1) Make sure that the weight of the
luggage does not exceed the
allowable roof load.
If the allowable roof load is ex-
ceeded, this may cause damage
to the vehicle.
The roof load is the total allowable
load on the roof (the weight of the
roof carrier plus the weight of lug-
gage placed on the roof carrier).
For specific figures, please refer
to the ”Maximum roof load” on
page 10–6.
To Next Page
Loading...
Need help?
General
