18
WINDSHIELD & ROOF CONSOLE
®
To program HomeLink
®
to operate a garage door, gate, or entry door opener, home or office lighting,
you need to be at the same location as the device.
1. Press the HomeLink
®
button that you would like to program. The indicator light (A) will flash
orange slowly.
2. Position the end of your hand-held transmitter (B) 1 to 3 inches away from the HomeLink
®
button
while keeping the indicator light in view.
3. Press and hold the hand-held transmitter button while watching the indicator light (A). Continue
pressing the button until the indicator light (A) changes from slowly flashing orange to either
rapidly flashing green (rolling code) or continuously lit green (fixed code). Now you may release the
hand-held transmitter button.
4. Press the just-trained HomeLink
®
button and observe the
indicator light.
• If the indicator light stays on constantly green, programming is complete and your device
should operate when the HomeLink
®
button is pressed and released.
• If the indicator light rapidly flashes green, firmly press, hold for 2 seconds and release the
programmed HomeLink
®
button. Repeat the “press/hold/release” sequence a second time, and,
depending on the brand of the garage door opener (or other rolling code equipped device),
repeat this sequence a third time to complete the programming process. At this point if your
device operates, programming is complete.
• If the device does not operate, continue with “Programming a new HomeLink
®
” steps 5 to 7 to
complete the programming of a rolling code equipped device.
5. At the garage door opener receiver (motor-head unit) in the garage, locate the “Learn” or “Smart”
button. This can usually be found where the hanging antenna wire is attached to the motor-head
unit (see the garage door opener manual to identify the “Learn” button.
6. Firmly press and release the “Learn” or “Smart” button. (The name and color of the button may vary
by manufacturer.) There are typically 30 seconds to initiate step 7.
7. Return to the vehicle and firmly press, hold for 2 seconds and release the programmed HomeLink
®
button. Repeat the “press/hold/release” sequence a second time, and, depending on the brand of
the garage door opener (or other rolling code equipped device), repeat this sequence a third time
to complete the programming process. HomeLink
®
should now activate your rolling code
equipped device.
NOTE: Some hand-held transmitters may actually train better at a distance of 6 to 12 inches. Keep this
in mind if you have difficulty with the programming process.
1 - HomeLink
®
button 1
2 - HomeLink
®
button 2
3 - HomeLink
®
button 3
To Next Page
Loading...
Need help?
General
