'22 • PAC-SM-412
-
46
-
6. To remove the compressor (CM)
(1) Remove the service panel.(See No.1.)
(2) Remove the insulation which covers compressor. (Strings (a),(b) should be loosen.)
(3)
Remove the terminal cover xing bolt and remove it, and disconnect the power wiring.
(4)
Remove welded part of compressor by welding. (
□ mark)
(5)
Remove 2 compressor xing nuts(← mark) using spaner or adjustable wrench.
7. To remove the printed circuit board (PCB)
(1) Remove the service panel and top panel.
(2) Take off 4 hooks of lid and remove it.( 〇 mark, Pic. ①)
(3) Remove 6 cotrol PCB xing screws and remove it.( 〇 mark, Pic.②)
(4) Remove 2 cotrol box xing screws and remove it.(〇 mark, Pic.③,④)
(5) Take off 6 hooks of control box a
nd remove it.( 〇 mark, Pic.⑤)
(6) Remove 4 cotrol PCB(sub) xing screws and remove it.( 〇 mark, Pic.⑥)
Terminal cover
(b)
(a)
Lid of control box
①
Control PCB
②
③
④
⑥
Control
PCB(sub)
⑤
To Next Page
Loading...
