Mitsubishi FDT71VH - Page 186

-
185
-
'20 • PAC-SM-351
9. To remove the compressor (CM)
(1) Remove the service panel.(See No.1)
(2) Remove the insula
which covers compressors.
(Strings (a)
(d) should be loosen.)
(3)
Remove 3 terminal cover fixing bolts(
mark) and
remove it and disconnect the power wiring.
(4) Remove welded part of compressor by welding.
(
mark)
(5)
Remove 3 compressor fixing nuts(
mark) using spanner
or adjustable wrench.
10. To remove the printed circuit board (PCB)
(1) Remove the service panel and top panel. (2)
Pull off all the inserted connectors of control PCB.(Pic.
)
(3)
Take off 6 control PCB fixing locking support and remove it.(
mark, Pic. )
(4)
Remove 5 plate fixing screws and open it.(
mark, Pic. )
(5)
Pull off all the inserted connectors of inverter PCB.(Pic.
)
(6)
Take off 9 inverter PCB fixing locking support and remove it.(
mark, Pic. )
11. To remove the printed circuit board (PCB)
Hinge control type
(1) Remove the service panel. (2)
Pull off all the inserted connectors of control PCB.(Pic.
)
(3)
Take off 5 control PCB fixing locking supports and remove it.(
mark, Pic. )
(4)
Remove 2 plate fixing screws and open it.(
mark, Pic. )
(5)
Pull off all the inserted connectors of inverter PCB.(Pic.
)
(6)
Take off 6 inverter PCB fixing locking supports and remove it.(
mark, Pic. )