Initial setting (Contiued)
Initial setting (Contiued)
Resets all zone settings.
If this is acceptable, tap the
Yes
button.
(2) Zone name setting
①
Tap
Menu
button on the top screen.
②
Select
User setting
.
③
Select
Administrator settings
.
The service password input screen is
displayed.
Enter the service password "0000"(Defalt
setting).
④
Select
R/C display setting
.
⑤
Select
Zone name
.
Tap the zone you want to set a zone name
for.
The zone name input screen is displayed.
The zone name can be set with up to 8
2-byte letters (16 1-byte letters).
You can enter alphanumeric or Cyrillic.
Tap the
Back
or
Next
button to display
next character group.
When you have finished inputting the room
name, tap
Set
.
The zone name that was set is displayed
on the zone operation screen.
⑦
Test
(1) Zone ON/OFF operation
After performing the zone settings, the ‟Zones” button appears on the top screen.
①
Tap the ‟Zones” button.
②
Sets
ON
/
OFF
(OPEN/CLOSE) for each zone.
→
ON
→
OFF
→
SPL*1
*1: If there is no common zone, the spill zone is OFF, and one or more other zone are OFF,
the spill zone will open automatically and
SPL
will be displayed.
Attention
Common zone : A zone in which a damper is not installed.
Spill zone : A zone in which a damper open automatically.
'22 • PAC-SM-412
-
99
-
To Next Page
Loading...
