─ 20 ─
Reinforcement
9 Unscrew the screws (two screws, indicated by ) to
remove the reinforcement.
0 Unfasten the cord clips (two clips, indicated by ) to
release the motor lead wire.
Peel the sealing material.
9 Unscrew the screws (two screws, indicated by ) to
remove the reinforcement and sealing materials.
0 Unfasten the cord clips (two clips, indicated by ) to
release the motor lead wire.
When the motor lead wire is sealed as shown in the picture below
Reinforcement
Assembly precaution
After replacing the motor, set the center of packing material of the motor lead wire under the reinforcement.
It is not required to reinstall the metal part shown in the picture below.
Metal part
<Before replacing the motor>
<After replacing the motor>
Packing material
Sealing material
To Next Page
Loading...
