12-8 Simple inspection and service
3. Holding onto grip on the cab, pull lever .
This causes the cab to start rising.
4. Hold the grip and push the cab up until it is
stopped by cab stay .
5. Check that the end of the cab stay is properly
held in the cut (indicated by in the illustra-
tion) in the lock lever to confirm that the cab
stay is locked in position, then insert the safety
pin into the hole in the cab stay.
CAUTION
• If lever is not pulled down completely, the
hook may not be engaged when the cab is
lowered.
• Raise the cab only gently.
WARNING
Raise the cab only by holding the grip , not
the lever . Otherwise, the cab lock mecha-
nism may be damaged when the cab is low-
ered and will fail to lock the cab in position.
This condition is very dangerous as the cab
could accidentally tilt up when the vehicle
vibrates or receives shocks while driving,
possibly leading to an accident.
WARNING
To ensure safety, be sure to fit the safety pin
in the cab stay hole.
On no account climb under the cab before
the pin is in the hole.
<FK61F>
Z00602
<Other than FK61F>
Z05108
Z17490
FKFM.book Page 8 Wednesday, January 28, 2009 9:21 AM
To Next Page
Loading...
