12-70 Simple inspection and service
1Preparation of tire replacement
1. Park the vehicle on a flat, hard surface. Firmly
set the parking brake. In a manual transmission
vehicle, put the gearshift lever in the neutral
position. In an automatic transmission vehicle,
put the range selector lever in the “P” position
<other than FM65F> or “N” position <FM65F>.
2. If you get a flat tire while on the road and need
to change it on the spot, pull up your vehicle in a
safe place where it will not block traffic, and acti-
vate your hazard warning lamps to flash and use
a red or white flag or cloth to give warning pass-
ing vehicles.
3. Have all passengers get out of the vehicle.
4. Block the tire with a chock diagonally opposite to
the tire to be replaced.
Example:
Block the left front tire if the right rear tire is to be
replaced.
5. Prepare a replacement tire.
NOTE:
• Your vehicle is not provided with a replacement
tire as standard equipment.
• Specified tire types
FK61F: 225/70R 19.5
FK62F, FK65F: 10R22.5 – 14PR
FM: 11R 22.5 – 14PR
6. A socket wrench for removing and replacing
wheel nuts is stored in the box under the bed.
Tires – replacement
Z17368
For outer wheel nut
For inner
wheel nut
FKFM.book Page 70 Wednesday, January 28, 2009 9:21 AM
To Next Page
Loading...
