12-10 Simple inspection and service
3. Lower the cab until lever is engaged.
4. Push lever all the way up. If you cannot push
the lever up completely, raise the cab back,
then perform the above steps again.
5. Install lever key .
6. Make sure that the cab does not rise even when
lever is pulled.
7. Visually check that the main hook is engaged
with the pin .
8. Turn the starter switch to the “ON” position and
check that warning lamp does not light up. If
warning lamp is illuminated, perform the cab
tilting and lowering procedures over again.
CAUTION
Make sure that the intake air duct and its rubber
boot are perfectly aligned.
WARNING
Ensure that the lever key is correctly
installed. If the lever key is not in position,
the cab may be unlocked and tilt up acciden-
tally while driving, possibly leading to an
accident.
WARNING
Always check that the cab does not rise. If
the cab is not completely locked, it may tilt
up while driving, possibly leading to an acci-
dent.
WARNING
Always check the main hook’s engagement
with the pin. If the cab is not completely
locked, it may tilt up while driving, possibly
leading to an accident.
Z00605
Z00606
Z14640
Z16216
FKFM.book Page 10 Wednesday, January 28, 2009 9:21 AM
To Next Page
Loading...
