12-29
Quantity required:
Liters (qts)
2.1 Check
1. Remove inspection plug and make sure that
oil is topped off.
2. If insufficient, add oil through the inspection plug
hole until it is full to the brim.
3. After adding oil, wait at least 1 minute then put a
finger in the inspection plug hole as shown in
the illustration and check that the oil has come
up to the bottom of the hole.
CAUTION
The added oil should be of the same grade and
viscosity as the oil originally placed in the trans-
mission. Otherwise, malfunction of the trans-
mission will result.
4. Install the inspection plug.
Model Quantity
Other than FM65F
Approx.
6.7 (7.1)
Add
approx.
0.5 (0.5)
if vehicle
has PTO
FM65F
Approx.
8.1 (8.6)
WARNING
Do not check or replace the gear oil immedi-
ately after operating the vehicle since the
engine, transmission, exhaust pipe, and
other components will be extremely hot.
Inspection plug
tightening torque
69 ± 15 N·m
(51 ± 11.7 ft.lbs.,
7 ± 1.5 kgf·m)
Z12097
*: drain plugs with a magnet
*
Z17998
FKFM.book Page 29 Wednesday, January 28, 2009 9:21 AM
To Next Page
Loading...
