12-41
6. Put the connector and its harness in the special
tool (separately sold).
CAUTION
When replacing the fuel filter, be sure to use the
special tool to avoid damaging the filter. If you
do not have the special tool, please contact an
authorized dealer.
7. Remove the filter case using the special tool,
by turning it in the direction of the arrow .
8. Remove the element and the sensor from the
filter case.
9. Replace the O-ring and O-ring with new
ones. Apply a thin coat of engine oil to each of
the new O-rings and install the O-ring on the
filter case and the O-ring on the sensor.
CAUTION
Use the O-rings that are supplied with the new
replacement element.
10. Clean the surfaces of the filter head and fil-
ter case that will come in contact with the O-
ring .
11. Install the element with the hole of its end facing
upward. Be sure to use a genuine replacement
element.
CAUTION
• When installing the filter case, be careful not
to let the O-ring twist and be damaged.
• Do not reuse the element.
Z12285
Z12117
Z11924
FKFM.book Page 41 Wednesday, January 28, 2009 9:21 AM
To Next Page
Loading...
