12-76 Simple inspection and service
Single wheels
Tighten the wheel nuts to the specified torque. Fol-
low the diagonal tightening sequence indicated in
the figure.
Dual wheels
Retighten the wheel nuts using the following 2-pro-
cess procedure.
1st process
1. Loosen the outer wheel nuts as follows:
6-bolt type: Loosen the nuts numbered 1 - 4 - 5
or 2 - 3 - 6 in the figure in this order.
8-bolt type: Loosen the nuts numbered 1 - 2 - 3 -
4 or 5 - 6 - 7 - 8 in the figure in this
order.
2. Tighten the inner wheel nuts corresponding to
the loosened outer wheel nuts to the specified
torque.
3. Apply a thin coat of chassis grease, wheel bear-
ing grease or engine oil to the external threads
of inner wheel nuts and the spherical surfaces
of outer wheel nuts. Tighten the outer wheel
nuts to the specified torque.
2nd process
4. Perform the above steps 1 through 3 for the
remaining outer wheel nuts and inner wheel
nuts.
WARNING
Wheel nuts that are tightened loosely or too
tightly could lead to broken or elongated
wheel bolts, cracked disc wheels, and/or
worn or cracked wheel hubs, causing wheels
to come off the axles. Since this could cause
a serious accident and render the vehicle
undriveable, be sure to check the wheel nuts
regularly.
1
2
3
45
6
Z12130
<FK61F>
1
2
3
5
6
7
8
4
Z10057
<Other than FK61F>
Z00397
FKFM.book Page 76 Wednesday, January 28, 2009 9:21 AM
To Next Page
Loading...
