13-23
CAUTION
A vehicle with its parking brake released by this
emergency procedure must be towed by only a
tow vehicle specially designed for the purpose.
1. Remove the release bolt , nut , and washer
from the rear brake chamber.
2. Remove the plastic cap from the brake cham-
ber.
3. Insert the release bolt head-first into the hole in
the brake chamber. Push the release bolt until it
stops.
4. Give the release bolt 1/4 of a turn clockwise,
then check that it cannot be pulled out.
5. Fit the washer and nut onto the release bolt.
Then, turn the nut down the bolt using a wrench
with a face-to-face dimension of 19 mm (3/4 in.).
The parking brake will be completely released
when the distance L from the nut’s top surface
to the bolt’s free end is equal to the following
value.
CAUTION
To avoid damaging the brake chamber, do not
turn the nut further than the indicated distance
L from the bolt’s free end.
Model Distance L
FK62F, FK65F 82 mm (3.23 in.)
FM65F 76 mm (2.99 in.)
Z05965
Z04178
Z04179
L
FKFM.book Page 23 Wednesday, January 28, 2009 9:21 AM
To Next Page
Loading...
