15-3
Retightening, inlet and
exhaust manifold bolts
••••T
Retighten. Checking of the tight-
ening torque is unnecessary.
–
Valve clearance • • • • I
Check valve clearance with
thickness gauge.
–
Oil filter replacement • •
Every
20‚000 km/
12‚000 miles
On new vehicle,
also replace at
the first
10‚000 km/
6‚000 miles.
Replace element. 12-38
Fuel filter replace-
ment
• • • R • Replace element. 12-39
Draining water and
sediment in fuel tank
• • Every 24 months
Remove fuel tank drain plug and
remove water and sediment.
12-66
Retightening the fuel
tank bracket bolts
••T••
Check the bolts for looseness
and retighten to a torque of 69 to
93 Nm (51 to 68 lb.ft, 7.0 to 9.5
kgm).
–
Check fuel line out-
side the engine com-
partment
• • Every 24 months
Check fuel line outside the
engine compartment.
Replace if necessary.
–
Belt tension and
damage
I•I••
Press midpoint of belt firmly with
finger to measure deflection and
check for belt damage.
12-56
Coolant level and leaks
from cooling system
I••••
Check coolant level and if level
is low, check for coolant leaks.
12-48
Coolant replacement • • Every 24 months Replace with new coolant. 12-48
Radiator cap condition • • I • •
Check radiator cap for sealing
and mounting condition.
–
Cooling system hose
clamp position and
clamping condition.
••I••
Check clamp position and
clamping condition of cooling
system hose.
–
Turbocharger rotor
play
••
Every
250‚000 km/
150‚000 miles
Check rotor for excessive end
play by using a dial indicator.
–
Item
Time of inspection and
maintenance
Working procedures
Ref.
page
Pre-operational checks
New vehicle at 4,000 km/
2,500 miles
Inspection
interval
Every 10,000 km/
6,000 miles
Every 30,000 km/
18,000 miles *1
Every 60,000 km/
36,000 miles *2
FKFM.book Page 3 Wednesday, January 28, 2009 9:21 AM
To Next Page
Loading...
