5-35
3. Push the DOWN side of the height control
switch to lower the cargo bed.
NOTE:
• The system will prevent the cargo bed from low-
ering if the vehicle is in any of the following con-
ditions.
• The parking brake is not applied.
• The starter switch is not in the “ON” or “ACC”
position.
• The gear shift lever is not in “neutral” (vehi-
cle with manual transmission).
• The range selector lever is not in the “P” or
“N” range (vehicle with automatic transmis-
sion).
• If either of the following operations are per-
formed during the lowering process, the cargo
bed will automatically return to driving height.
The height control switch will automatically
return to OFF.
• The parking brake is released.
• The starter switch is turned to positions other
than “ON” or “ACC”.
• The gear shift lever is moved out of “neutral”
(vehicle with manual transmission).
• The range selector lever is moved out of the
“N” or “P” range (vehicle with automatic
transmission).
2 Returning the cargo bed to driving
height
Push the OFF side of the height control switch to
automatically return the cargo bed to driving height.
NOTE:
Be sure to push the OFF side of the height control
switch before the vehicle is driven.
Z17289
Z17290
FKFM.book Page 35 Wednesday, January 28, 2009 9:21 AM
To Next Page
Loading...
