GENERAL - Support Locations for Lifting and Jacking
00-25
SUPPORT POSITIONS FOR AXLE STANDS AND A SINGLE-POST LIFT OR
DOUBLE-POST LIFT
Caution
1. If rubber attachments with grooves that are too thick are used at the front support positions,
the front fender may become bent, so be sure to use rubber attachments with groove thicknesses
of 18 mm or less.
2. If attachments which are not high enough are used, they may damage areas such as the side
step. Be sure to use attachments which are high enough, or remove the side step if not using
attachments.
Bolts
Rubber
Rubber
Bolts
Side sill rear end
Side sill rear end
Attachment
Attachment
AXLE STANDS
SINGLE-POST
LIFT OR DOUBLE-
POST LIFT
To Next Page
Loading...
Need help?
General
