To Next PageTo Next PageHow to fix large measured value error on Mitsubishi ME110NSR-MB?
If you are getting a large error in measured value with your Mitsubishi Measuring Instruments, the primary voltage and primary current settings may be incorrect. To resolve this, check the set value in the set value confirmation mode.
Why are W, var, cosf values showing large errors on Mitsubishi ME110NSR-MB?
If the measured values of W, var, cosf include large errors in your Mitsubishi Measuring Instruments, the wiring may be erroneous. To fix this, check the wire.
How to fix Mitsubishi Measuring Instruments when the display is not lit?
If the display of your Mitsubishi Measuring Instruments is not lit, it may be because the auxiliary power supply is not impressed on MA and MB terminals. Impress auxiliary power supply to resolve this.
What to do if Mitsubishi ME110NSR-MB voltage display shows FULL?
If 'FULL' is displayed on the voltage display of your Mitsubishi Measuring Instruments, there may be an inconsistency between wiring and set value (direct voltage setting, or secondary voltage setting). Check the wiring and set value to resolve this.
Why can't I set up Mitsubishi ME110NSR-MB when pressing SET?
If you cannot make set-up changes on your Mitsubishi Measuring Instruments even when pressing SET, it may be because the set value confirmation mode is active. Press SET and RESET simultaneously for 2 seconds to get into the set-up menu.
How to fix the back light on Mitsubishi ME110NSR-MB?
If the back light is not lit on your Mitsubishi Measuring Instruments, it may be because the back light is set to auto off. When any of the operation key is pressed, it is lit for 5 minutes. You can use it as it is, or change the setting to continuous lighting in the set-up menu 2.
Why is cosf value showing large error on Mitsubishi ME110NSR-MB?
If the measured values of cosf include large error in your Mitsubishi Measuring Instruments, it may be because the input current is smaller than the rating (about 5% or below of rated current). This is not an error. If error is troublesome, change the CT to one to meet the actual use current.
Why is the maximum value not held on Mitsubishi ME110NSR-MB?
If the maximum value is not being held on your Mitsubishi Measuring Instruments, it might be because the RESET button is being pressed continuously. Release RESET to resolve this.
What to do if HI and A values are largely different on Mitsubishi ME110NSR-MB Measuring Instruments?
If the harmonic total RMS value of harmonic current (HI) is largely different from current (A) value on your Mitsubishi Measuring Instruments, it may be because the distortion ratio (containing ratio) exceeds 100% largely (measurement of secondary output of inverter). Check measured environment.
Why does the Mitsubishi ME110NSR-MB display become black?
If the display of your Mitsubishi Measuring Instruments becomes black, it may be due to static electricity. It goes off after a while.
General| Brand | Mitsubishi |
|---|---|
| Model | ME110NSR-MB |
| Category | Measuring Instruments |
| Language | English |
Guidelines for safe and proper instrument installation.
Description of the instrument's capabilities and functions.
Explanation of the instrument's display elements and operational buttons.
Describes the three operating modes: Operation, Set-up, and Set value confirmation.
Comprehensive guide to configuring the instrument's parameters.
Sets alarm items and their upper/lower limit values.
Configures analog/pulse output settings and items.
Configures communication parameters for CC-Link.
Configures communication parameters for ModBus.
Performs a test of the alarm circuit.
Shows how to view, cycle, and reset max/min values.
Describes alarm indication, output, and cancellation methods.
Lists common issues, causes, and solutions.
