6
While carrying the F.A.S.T.-key within the operating range, the Start/
Stop button can be used to start the engine.
• Move the selector lever in “P” position and hold the brake pedal
down, push the Start/Stop button.
• To stop the engine, stop the vehicle completely and move the
selector lever in “P” then press the Start/Stop button.
* If you have to bring the engine to an emergency stop while
driving, press and hold the Start/Stop button for 3 seconds or more, or press it quickly 3 times
or more.
• If you press the Start/Stop button without depressing the brake pedal, you can change
the operation mode in the order of OFF, ACC, ON, OFF.
• If the engine cannot be started or the operation mode cannot be changed, check the
position of the F.A.S.T.-key or the battery performance of the F.A.S.T.-key.
TECHNOLOGY
Active Stability Control (ASC) Off Switch
You can deactivate the system by pressing down the “ASC OFF”
switch for 3 seconds or longer.
When the ASC is deactivated, the indicator will turn on. To
reactivate the ASC, momentarily press the “ASC OFF” switch; the
indicator is turned off.
This indicator will be displayed when fuel
efficient driving is achieved.
Tire Pressure Monitoring System (TPMS)
The Tire Pressure Monitoring System light illuminates when one or
more of your tires is significantly under inflated. Please note that
changes in the outside temperature may decrease tire pressure causing
the TPMS light to turn on. If the TPMS light remains illuminated,
check your tire pressure.
If the warning light illuminates, take the necessary measures referring
to the owner’s manual.
Start/Stop Engine Switch (if equipped with F.A.S.T.-key)
If the F.A.S.T.-key is not operating properly
Remove the key from the F.A.S.T.-key remote and unlock the door manually. Then, insert
the F.A.S.T.-key into the key slot in the instrument panel. Starting the engine and changing
the operation mode should be now possible. Remove the F.A.S.T.-key from the key slot
after starting the engine or changing the operation mode.
A
While carrying
the F.A.S.T.-
key, press the
driver’s door
lock/unlock
switch A .
Keyless Entry System
F.A.S.T.-Key Normal Key
Operation indicator light
LOCK (
) button
UNLOCK (
) button
PANIC button
Setting the Clock
1. Press and hold the
button and the clock
display flashes.
2. Press the
or button to adjust the “hours” digit.
If you keep pressing the button, fast-forward begins.
3. When the “hours” digit is adjusted, press the
button to
flash the “minutes” digit.
Press the
or button to adjust the “minutes” digit.
If you keep pressing the button, fast-forward begins.
4. When the time is set, press the
button to stop the clock
display from flashing.
To Next Page
Loading...
Need help?
General
