Mitsubishi MT160D User Manual

FRONT AXLE & STEERING LINKAGE SYSTEM
(2) Rig up a dial gauge on final case, putting
the gauge spindle to a teeth of pinion (1ST)
(the pinion on the bottom end of final-
drive shaft).
Take a backlash reading. This
backlash
is prescribed to be within this
range:
0.2 ~ 0.4 mm
Pinion (l6T) backlash (0.008 ~ 0.016 in.)
(3)
If the reading is off the specified range,
take
off the gear case and adjust the shim
between the pinion (16T) on differential
shaft and the ball bearing. The shim stock
for this adjustment comes in these thick-
necesses:
Thickness
Part No.
Shim set
10190626000
0.1 mm (0.004 in.)
11353016000
0.2 mm (0.008 in.)
0731 0002 502
0.4 mm (0.016 in.)
0731 0002 504
4-12
(4) Having ascertained a proper pinion (16T)
backlash, grease "0" ring and fit it to the
mating face of axle housing. Secure the
gear case to the housing by tightening the
bolts to this torque value:
"
15.0 ~ 6.0 kg-m
Tlghtemng torque (36 ~ 43 ft-lb)
Lower side reamer bolts
(:
L

Mitsubishi MT160D Specifications

General

Brand	Mitsubishi
Model	MT160D
Category	Tractor
Language	English