8
6. If the battery temperature becomes too high, charging
may stop.
7. Open the cap on the normal charge connector. Hold the
handle of the connector and, without pressing the button,
insert the connector until it clicks.
8. The charging indicator on the instrument cluster should
illuminate. It goes out when charging is completed.
Normal charge connector
Cap
Button
MITSUBISHI Remote Control* enables timed charging and air
conditioning on your OUTLANDER PLUG-IN HYBRID. For details,
go to mmnz.co.nz/plug-in-hybrid
Charging indicator
* MITSUBISHI Remote Control enables you to
remotely control your OUTLANDER PLUG-IN
HYBRID using dedicated applications over a
connection between your vehicle and a wireless
LAN device. Available on VRX models only.
If the charge cable is connected to the charge port, it is not
possible to start the vehicle. Operation of the radio, heater,
and air conditioning is possible when connected to the
charge port.
Once the battery is completely charged, the on board
charging system will stop charging the vehicle. There is
no need to unplug the vehicle until use of the vehicle is
required.
To Next Page
Loading...
Need help?
General
