17
Cause/Error display
Cause/Error display
22
22
2
No paper
[Symptom]
• When the paper runs out or the paper is not installed, printing
becomes impossible and an alarm tone is heard.
In this case, all the buttons become invalid.
• If this error occurs while more than one copy is being printed or
there are images waiting to be processed, printing is cancelled
at the occurrence of the error.
Symptom/Remedy
Symptom/Remedy
[Remedy]
Install a new roll of paper according to "5. INSTALLATION OF
PAPER" on page 8.
When the paper is correctly installed while the printing of more than
one copy has been suspended or there are images waiting to be
processed, an alarm tone is heard. Then, the paper is fed automati-
cally about 15 cm and printing resumes.
After the error is resolved, the unit resumes printing from the inter-
rupted image and finishes printing all the outstanding images.
33
33
3
Button input
error
[Symptom]
• The button becomes invalid and an alarm tone is heard in the
following cases.
• During adjusting the printer brightness or the printer contrast,
the UP button is pressed exceeding the upper limit value (LED
display :
) or the DOWN button is pressed exceeding the
lower limit value (LED display : )
• The UP or DOWN button is pressed when the button func-
tions are locked with the LOCK button or the DIP switch No. 1.
The indicator displays “ ” for one second and return to the status
before the error occurred.
To Next Page
Loading...
Need help?
General
