PBV20N2 PBV20N2 Service Service ManualManual
CODE
CODE TRUCKTOOL TRUCKTOOL AND AND DISPLAY DISPLAY DESCRIPTIONDESCRIPTION
243243 Error in pump command value rangeError in pump command value range
PUMP VACC RANGEPUMP VACC RANGE
(Alarm)(Alarm)
This alarm indicates that the lift lever voltage is out of range.This alarm indicates that the lift lever voltage is out of range.
In such a case, check the following:In such a case, check the following:
•
• Teach the lift lever values again.Teach the lift lever values again.
•• Check that the connectors and cables are in order.Check that the connectors and cables are in order.
•
•
Replace the lift lever and tReplace the lift lever and teach the new values.each the new values.
245245 Error in the pump command valueError in the pump command value
PUMP VACC NOT OKPUMP VACC NOT OK
(Alarm)(Alarm)
This alarm occurs when the lift lever output This alarm occurs when the lift lever output voltage differs from the values acquired atvoltage differs from the values acquired at
calibration.calibration.
In such a case, check the functionality of In such a case, check the functionality of the lift lever. Perform the the lift lever. Perform the lift lever calibration wizardlift lever calibration wizard
function.function.
246246
Error in magnetic brake driver errorError in magnetic brake driver error
AUX DRIV. OPENAUX DRIV. OPEN
(Alarm) Stored(Alarm) Stored
This alarm indicates that the driver of This alarm indicates that the driver of the electromagnetic brake coil is not able the electromagnetic brake coil is not able to drive theto drive the
load.load.
The driver inside the COMBIACX controller is damaged, so the controller has The driver inside the COMBIACX controller is damaged, so the controller has to be replaced.to be replaced.
247247 Acquisition of gain valuesAcquisition of gain values
DATA ACQUISITIONDATA ACQUISITION
(Warning)(Warning)
This warning indicates acquisition of the current gains.This warning indicates acquisition of the current gains.
The warning disappears when the acquisition is The warning disappears when the acquisition is done. This alarm is a part done. This alarm is a part of normal operationof normal operation
of the controller.of the controller.
248248 Curtis display not presentCurtis display not present
NO CAN MSG.NO CAN MSG.
(Alarm) Stored(Alarm) Stored
This alarm is displayed where there is no This alarm is displayed where there is no CAN message from the Curtis display.CAN message from the Curtis display.
This alarm can be caused by a This alarm can be caused by a CAN bus malfunction, which blinds the traction-displayCAN bus malfunction, which blinds the traction-display
communication. If not, it is an communication. If not, it is an internal problem in the COMBIACX controller or in the internal problem in the COMBIACX controller or in the CurtisCurtis
display.display.
249249
Call for programmed maintenanceCall for programmed maintenance
CHECK UP NEEDEDCHECK UP NEEDED
(Warning)(Warning)
This is just a This is just a warning calling for programmed maintenance.warning calling for programmed maintenance.
Set the CHECK UP DONE parameter to the ON value after Set the CHECK UP DONE parameter to the ON value after the maintenance is carried out.the maintenance is carried out.
250250 Controller thermal sensor failureController thermal sensor failure
THERMIC SENS. KOTHERMIC SENS. KO
(Warning) Stored(Warning) Stored
This warning indicates that the output of the controller thermal sensor is out of range.This warning indicates that the output of the controller thermal sensor is out of range.
This fault is not This fault is not related to external components, so when it appears, replace the related to external components, so when it appears, replace the COMBIACXCOMBIACX
controller.controller.
To Next Page
Loading...
