© Mitsubishi Forklift Trucks 2013. All
© Mitsubishi Forklift Trucks 2013. All rights reserved.rights reserved. Revision: BRevision: B
Document ID: 615023Document ID: 615023
43 (244)43 (244)
PBV20N2 PBV20N2 Service Service ManualManual
1.1. Remove the front screw from theRemove the front screw from the
gas spring’s triangular gas spring’s triangular mountingmounting
plate.plate.
2.2. Fold the side guard in.Fold the side guard in.
3.3. Remove the gas spring. Note theRemove the gas spring. Note the
location of the wiring.location of the wiring.
4.4. Check the condition of the ball jointsCheck the condition of the ball joints
holding the gas spring in place.holding the gas spring in place.
Replace ball joints, if Replace ball joints, if needed.needed.
5.5. Install the new gas spring. Make sure Install the new gas spring. Make sure that the location of the wiring that the location of the wiring is the sameis the same
as it was with the old spring.as it was with the old spring.
6.6. Fasten the front screw on the Fasten the front screw on the triangular mountintriangular mounting plate.g plate.
To Next Page
Loading...
