Mitsubishi PBV20N2 - Page 45



© Mitsubishi Forklift Trucks 2013. All
© Mitsubishi Forklift Trucks 2013. All rights reserved.rights reserved. Revision: BRevision: B
Document ID: 615023Document ID: 615023
45 (244)45 (244)

PBV20N2 PBV20N2 Service Service ManualManual
CAUTIONCAUTION
After removing the rubber absorbers, beware of sharp edges when After removing the rubber absorbers, beware of sharp edges when removing theremoving the
operator’s platform.operator’s platform.
When installing the rubber absorbers, remember to use locking glue When installing the rubber absorbers, remember to use locking glue (for example,(for example,
Loctite 243).Loctite 243).
After the rubbeAfter the rubber absorbers have r absorbers have been remobeen removed, you can ved, you can remove the oremove the operator’sperator’s
platform:platform:
1.1. Remove the two screws under theRemove the two screws under the
operator’s platform.operator’s platform.
2.2. Remove the operator’s platform.Remove the operator’s platform.
CAUTIONCAUTION
When removing the operator’s platform, note that it weights 35 When removing the operator’s platform, note that it weights 35 kg.kg.
NOTE: When installing the operator’NOTE: When installing the operator’s platform, place a support, such as s platform, place a support, such as a block ora block or
similar, between the operator’s platform and the mounting bracket to prevent thesimilar, between the operator’s platform and the mounting bracket to prevent the
operator’s platform from lifting too much. Seeoperator’s platform from lifting too much. SeeFigure 29Figure 29 below.below.
https://www.forkliftpdfmanuals.com/