Mitsubishi PBV20N2 - Page 60



© Mitsubishi Forklift Trucks 2013. All
© Mitsubishi Forklift Trucks 2013. All rights reserved.rights reserved. Revision: BRevision: B
Document ID: 615023Document ID: 615023
60 (244)60 (244)

PBV20N2 PBV20N2 Service Service ManualManual
NOTE: To access the castor wheels, lift NOTE: To access the castor wheels, lift the truck up (see the the truck up (see the correct lifting points incorrect lifting points in
the sectionthe section5.15.1 of this manual).of this manual).
5.12.1 5.12.1 Disassembly Disassembly of of the the castor castor wheelwheel
1.1. Open the nut holding the castorOpen the nut holding the castor
wheel bolt in the bracket.wheel bolt in the bracket.
2.2.
Remove the bolt holding the castorRemove the bolt holding the castor
wheel in the bracket.wheel in the bracket.
3.3. Remove the castor wheel from theRemove the castor wheel from the
bracket.bracket.
4.4. Remove the sleeves from theRemove the sleeves from the
bearing and save them.bearing and save them.
5.12.2 5.12.2 Adjusting Adjusting the the castor castor wheelswheels
The castor wheels need to be adjusted according to the The castor wheels need to be adjusted according to the wear of the traction wheel:wear of the traction wheel:
•
• In a new truck, the castor wheels are in location 1 shown inIn a new truck, the castor wheels are in location 1 shown inFigure 39.Figure 39.
•• When the traction wheel’s diameter reaches 220 mm, move the castor wheels toWhen the traction wheel’s diameter reaches 220 mm, move the castor wheels to
location 2.location 2.
•
•
 When the traction wheel’s diameter reaches 214 When the traction wheel’s diameter reaches 214 mm, replace the traction mm, replace the traction wheelwheel
and move the castor wheels back to and move the castor wheels back to location 1.location 1.
https://www.forkliftpdfmanuals.com/