© Mitsubishi Forklift Trucks 2013. All
© Mitsubishi Forklift Trucks 2013. All rights reserved.rights reserved. Revision: BRevision: B
Document ID: 615023Document ID: 615023
73 (244)73 (244)
PBV20N2 PBV20N2 Service Service ManualManual
Figure 44. Page 1/8, zone 13, wiring reference J14Figure 44. Page 1/8, zone 13, wiring reference J14
Note the numbers above the wiring reference J14. These numbers (8/16) direct you Note the numbers above the wiring reference J14. These numbers (8/16) direct you toto
the page and zone where the wire is connected.the page and zone where the wire is connected.
This procedure is used to follow This procedure is used to follow the circuits throughout the schematic diagram. If thethe circuits throughout the schematic diagram. If the
numbers are given without the slash (/), numbers are given without the slash (/), the connection is on the same page of the connection is on the same page of thethe
schematics.schematics.
Table 2Table 2 below explains the different identifiers used in below explains the different identifiers used in the schematic diagram. # standsthe schematic diagram. # stands
for a number.for a number.
Table 2. Schematic diagram identifiersTable 2. Schematic diagram identifiers
IDENTIFIER DESCRIPTION
IDENTIFIER DESCRIPTION
S#S#
Switches and other state Switches and other state changing devices (for example, most sensors).changing devices (for example, most sensors).
#F##F#
FuseFuse
J# Reference.J# Reference.
All references markAll references marked with an even ”J” (e.g. Jed with an even ”J” (e.g. J2) are positive (+). All2) are positive (+). All
references marked with an odd “J” (e.g. J3) are references marked with an odd “J” (e.g. J3) are negative (-).negative (-).
To Next Page
Loading...
