Mitsubishi PBV20N2 - Page 93

gg ( )( )


© Mitsubishi Forklift Trucks 2013. All
© Mitsubishi Forklift Trucks 2013. All rights reserved.rights reserved. Revision: BRevision: B
Document ID: 615023Document ID: 615023
93 (244)93 (244)
PBV20N2 PBV20N2 Service Service ManualManual
8.1.5 8.1.5 Installing Installing the the acceleratoraccelerator
1.1. Connect the accelerator wires to Connect the accelerator wires to the accelerator connector. The pin locationsthe accelerator connector. The pin locations
from 1 to 3 from 1 to 3 are marked on the connector with lines and help you are marked on the connector with lines and help you in determiningin determining
the rest of the rest of the pin locations. Details of the accelerator wires and the pin locations. Details of the accelerator wires and their pintheir pin
locations are available inlocations are available inFigure 54Figure 54 andandTable 3Table 3 below.below.
2.2. Install the Install the accelerator.accelerator.
3.3. Install the mounting bracket and tighten the screws.Install the mounting bracket and tighten the screws.
4.4. Fit the accelerator connector to the mounting bracket.Fit the accelerator connector to the mounting bracket.
5.5. Install the microswitch bracket.Install the microswitch bracket.
6.6. Install the safety button. For instructions, see Install the safety button. For instructions, see the sectionthe section8.1.38.1.3 above, justabove, just
perform the steps in reversed order.perform the steps in reversed order.
7.7. Assemble the Assemble the tiller arm. For instructiotiller arm. For instructions, see the sens, see the sectionction5.155.15 above, just performabove, just perform
the steps in reverse order.the steps in reverse order.
8.8. Calibrate the accelerator. For instructions, see the sectionCalibrate the accelerator. For instructions, see the section9.1.9.1.
Figure 54. Accelerator pin locationsFigure 54. Accelerator pin locations
Table 3. Accelerator wire detailsTable 3. Accelerator wire details
PIN
PIN WIRE WIRE COLOR COLOR DESCRIPTIONDESCRIPTION
11
Red/Green Red/Green Sensor Sensor +24 +24 VV
22
- - --
33
White/Black White/Black Backward Backward signalsignal
44
White White Forward Forward signalsignal
55
Orange Orange Sensor Sensor GNDGND
66
Black Black Sensor Sensor analogue analogue outputoutput
77
White/Brown White/Brown Sensor Sensor 0 0 VV
https://www.forkliftpdfmanuals.com/