A - 13 A - 13
How to use this manual
• Please read Chapter 1 through Chapter 11 and the Appendix if the manual should be used with Interpreter
BASIC. It is not necessary to read Chapter 12.
• Please read Chapter 12 and understand the restrictions of the compiler if the manual should be used with
Compiler BASIC. Then proceed to read Chapter 1 through Chapter 11 and the Appendix.
Regarding Compiler BASIC
• Please be aware that there are many detailed restrictions for each instruction when using Compiler BASIC.
See Section 12.8.2 for details on these restrictions.
• An assembler and a linker is required to compile programs. These are not included in the SW1IVD-
AD51HP/SW1NX-AD51HP software package and must be purchased separately.
Recommended Products
• IBM/AT Compatible Personal Computer
Turbo Assembler Ver 5.0
Inprise Corporation
1-64-8 Sasazuka South Building, Sasazuka, Shibuya-ku, Tokyo 151-0073
TEL 03-5350-9380
• PC-9800 Series
Macro Assembler Ver 6.0
Microsoft Corporation
1-50-1 Sasazuka NA Building, Sasazuka, Shibuya-ku, Tokyo 151-8533
TEL 03-5454-8000
• MS-DOS is used for the Compiler BASIC. The user must have adequate knowledge about MS-DOS to use
it.
About Module Names
The module model names are abbreviated as follows in this manual.
AD51H-S3 • • • • • Refers to operations only for the AD51H-S3.
A1SD51S • • • • • Refers to operations only for the A1SD51S.
QD51 • • • • • Refers to operations only for the QD51.
QD51-R24 • • • • • Refers to operations only for the QD51-R24.
QD51 (-R24) • • • • • Refers to common items for both the QD51 and the QD51-R24.
Communication Module • • • • • Refers to common items for all modules.
To Next Page
Loading...
