Mitsubishi QD75M2

Type QD75M Positioning Module User's Manual(Details)
U
User's Manual(Details) User's Manual
Mitsubishi Programmable
Logic Controller
Type QD75M Positioning Module Type QD75M Positioning Module
QD75M1
QD75M2
QD75M4
B
IB(NA)-0300062-A(0212)MEE
MODEL
MODEL
CODE
QD75M-U-S-E
1CT752
IB(NA)-0300062-A(0212)MEE
When exported from Japan, this manual does not require application to the
Ministry of Economy, Trade and Industry for service transaction permission.
HEAD OFFICE : 1-8-12, OFFICE TOWER Z 14F HARUMI CHUO-KU 104-6212,JAPAN
NAGOYA WORKS : 1-14 , YADA-MINAMI 5 , HIGASHI-KU, NAGOYA , JAPAN
Specifications subject to change without notice.
(Details)

Mitsubishi QD75M2 Specifications

General

Product Series	QD75
Number of Axes	2
Maximum Pulse Output	4 Mpulses/s
Power Supply Voltage	24V DC
Input Signals	24 V DC (sink/source)

Summary

SAFETY INSTRUCTIONS

[Design Instructions]

Provides critical safety instructions for system design, emergency stop circuits, and interlocks to prevent mechanical damage.

[Mounting Instructions]

[Wiring Instructions]

[StartupMaintenance Instructions]

Section 1 Product Specifications and Handling

Chapter 1 Product Outline

Explains the purpose and outline of positioning control using QD75, including system structuring.

Chapter 2 System Configuration

Details the system configuration of positioning control using QD75, including devices, applicable CPU, and precautions.

Chapter 3 Specifications and Functions

Explains the various specifications of the QD75, covering general, performance, I/O, and interface specifications.

Chapter 4 Installation, Wiring and Maintenance of the Product

Describes installation, wiring, and maintenance of the QD75, including important information on precautions and proper work methods.

Chapter 5 Data Used for Positioning Control (List of buffer memory addresses)

Explains the types of data used for positioning control, including parameters, monitor data, and control data.

Chapter 6 Sequence Program Used for Positioning Control

Explains the programs required for positioning control, covering general control configuration and program details.

Chapter 7 Memory Configuration and Data Process

Section 2 Control Details and Setting

Chapter 8 OPR Control

Explains the details and usage of "OPR control," which establishes a starting point for positioning.

Chapter 9 Major Positioning Control

Details the major positioning controls like position, speed, and switching controls, explaining required settings.

Chapter 11 Manual Control

11.1 Outline of manual control

Explains manual control methods, including JOG operation, inching operation, and manual pulse generator operation.

11.2 JOG operation

Details JOG operation, including its outline, execution procedure, parameter settings, and examples.

11.3 Inching operation

Explains inching operation, covering its outline, execution procedure, parameter settings, and examples.

11.4 Manual pulse generator operation

Details manual pulse generator operation, including its outline, execution procedure, parameter settings, and program creation.

Chapter 13 Common Functions

13.2 Parameter initialization function

Describes how to initialize parameters, returning setting data in buffer memory and flash ROM to factory-set values.

13.3 Execution data backup function

Explains the function for backing up execution data from buffer memory to flash ROM for data retention.

Chapter 15 Troubleshooting

15.1 Error and warning details

Explains the errors and warnings detected by the QD75, including their descriptions, causes, and operation status.

15.2 List of errors

15.3 List of warnings