Mitsubishi SCM45ZJ-S

-
8
-
'11 • SCM-SM-110
RUN (HOT KEEP) light (green)
・Illuminates during operation.
・ Blinks when airflow stops due to the ‘ HOT
KEEP ’ and ‘ CLEAN operation ’ .
ECONO light (orange)
Illuminates duri ng ECONOMY operation .
TIMER light (yellow)
Illuminates duri ng TIMER operation.
HI POWER light (green)
Illuminates duri ng HIGH POWER operation.
Unit ON/OFF button
This button can be used for turning on/o ff the
unit when remote control is not available.
Remote control signal receiver
ON
OFF
1.5 sec.
0.5 sec.
HOT KEEP
3 sec.
1 sec.
ON
OFF
CLEAN operati on
(c) SRR series
Each time the button is pressed, the
display is switched over in turn.
These buttons set the room temperature.
(These buttons are used for setting the
current time and timer function as well.)
Each time the button pressed, the
display is switched over in turn.
Press to start operation, press again to
stop.
ACL switch
This switch is for resetting microcomputer
and setting time.
This button changes the air flow (up/down)
direction.
This button is not used.
(Air flow direction adjustment can not be
performed.)
Operation section
Remote controller
Unit display section