1BasicSet
and tion
Package Contents
Please take a moment to review the following list of
items to ensure that you have received everything.
Remote
Control
Two AA
Batteries
Basic Quick
Owner's Setup
Guide Guide
TV Overview
Sample TV controls and
location of the STATUS
indicator. See page 31.
840 Series.
Calibration
Microphone
Product
Registration
Card
f
Installing the Remote Control
Batteries
1, Remove the remote control's back cover by
gently pressing in the tab and lifting off the cover.
Load the batteries, making sure the polarities
(+) and (-) are correct. For best results, insert
the negative (-) end first.
3, Snap the cover back in place.
The remote
control
requires two
AA batteries.
®
JJiIl_
Connection
Jacks
.Lamp-Compartment
Door
TV Control Panel
Buttons on the control panel duplicate some keys on
the remote control.
To display the main menu, press INPUTand VOL+simul-
taneously for about 10 seconds. Press and hold INPUT
and MOL+for 10 seconds to clear the menu.
System Reset
If the TV fails to respond to the remote control, the
control-panel buttons, or will not power on/off, perform
System Reset. Press and hold the POWERbutton on the
control panel for ten seconds.
Before You Begin
1, Review the important safety, installation, and oper-
ating information at the beginning of this book.
Choose a location for your TV.
• See the stand requirements on page 2.
• Allow at least four inches of space on all sides
of the TV to help prevent overheating. Over-
heating may cause premature failure of the TV.
• Avoid locations where light may reflect off the
screen.
3, Install the batteries in the remote control.
4° Plug the TV into an AC power outlet.
For assistance call 1(800) 332-2119
To Next Page
Loading...
Need help?
General
