Keep holding
down the【SET】
按住SET键
① ②
Short press ON/OFF
短按ON/OFF键
ESC enters“the throttle range”state:
ESC进入油门行程校准模式：
1. Turn on the transmitter, adjust the throttle trim to the middle position, and keep
the status of“D/R”,“EPA”,“ATL”and other parameters of the throttle channel
of the transmitter at 100%;
打开遥控器，将油门微调调至中间位置，同时请保持遥控器油门通道的“D/R”、“EPA”、
“ATL”等参数状态为100%；
2. The ESC is connected to the battery, but in the off state, keep holding down
the【SET】state, short press ON/OFF, the LED on the ESC will start to flash,
and at the same time, the motor will start to chirp, at this time, you can release
the【SET】button. The red light on the ESC is in the fast-flashing state, and it
has entered“the throttle range”state.
电调连接电池，但处于关闭状态，保持按住【SET】状态，短按ON/OFF，电调上LED开始
闪烁，同时电机开始鸣叫，此时即可松开【SET】按键。电调红灯处于快闪状态，已进入油门
行程校准状态。
Release the button
when the indicator
light flashes
指示灯闪烁时，即可
松开按键
When replacing the transmitter with a new one, it is recommended to reset the
throttle range, otherwise the ESC may become inoperable or abnormal.
当更换新的遥控器时，建议重新设置油门行程，否则可能会导致ESC无法使用或异常。
Set the throttle range (Transmitter calibration)
设定油门行程（遥控器校准）
Red light out
红灯熄灭
Calibration steps (please follow the order):
校准步骤 (请按照顺序进行)：
1. Keep the transmitter throttle in the mid-point position, press【SET】once, the red
light of ESC goes out and the motor“Di”, indicating that the mid-point position has
been successfully stored;
保持遥控器油门处于中点位置，按一次【SET】，ESC红灯熄灭，电机“Di”, 表明已成功储存
中点位置；
-9-
To Next Page
Loading...
