MJX HYPER GO 14303 - Page 11

The light
blinks twice
指示灯闪两下
2. Keep the throttle of the transmitter in the maximum forward position, press【SET】
once, the red light of ESC flashes twice and then goes out, the motor“Di.Di”,
indicating that the maximum forward position has been successfully stored;
保持遥控器油门处于最大前进位置，按一次【SET】，ESC红灯闪烁2次后熄灭，电机“Di.Di”,
表明已成功储存最大前进位置；
The light
blinks three
times
指示灯闪三下
3. Keep the transmitter throttle in the maximum backward position, press【SET】once,
ESC red light blinks 3 times and then goes out, motor“Di.Di.Di”, indicating that the
maximum backward position has been successfully stored.
保持遥控器油门处于最大后退位置，按一次【SET】，ESC红灯闪烁3次后熄灭，电机“Di.Di.Di”,
表明已成功储存最大后退位置。
After completing the above three steps, it means the calibration has been completed.
When the transmitter throttle returns to the centre position, the ESC can work normally.
完成以上三个步骤后，代表校准已完成。遥控器油门回到中点位置时，ESC即可正常工作。
It is recommended to perform a throttle travel calibration when starting a new vehicle to get
the most accurate experience.
建议新车入手时，进行一次油门行程校准，以获得最精准的体验。
Throttle range back to initial setting
油门行程恢复初始设置
When the ESC is powered on, press and hold【SET】for 5 seconds, the motor will emit
“Di.Di”, the ESC indicator light will flash twice, and the throttle range will be restored
to the initial setting.
在ESC通电并开启状态下，长按【SET】5秒，电机发出“Di.Di”, ESC指灯闪两下，油门行程恢复
为初始设置。
-10-