MMR SB1000 - Experiment Setup Configuration


Page|15
41 Daggett Drive, San Jose, CA 95134
Phone: +1 (650) 962 9620 Fax: +1 (650) 962-9647 Email: info@mmr-tech.com Web: www.mmr‐tech.com

GeneralOperation
Experiment Setup

 NewProject

 

AsmentionedintheSeebeckDefinitionsonPage12,theExperimentparameterscannowbeentered.
If no K2000 Temperature Controller is present select 'Skip Temperature Settings,' this will carry out the
experimentatAmbientTemperature(300Kwillbeusedforallcalculations).

SampleMounting
Stage:Selecttheappropriatestagetypethatthesampleismountedon.
HighImpedanceInput:SelecttheappropriateImpedanceSettingthatrelatestotheAmplifierinuse.
Gain:SelecttheappropriateGainvalue thatrelatestotheAmplifierinuse.

Note:ImpedanceandGain settings areindicated onthe Amplifier
boardinside thechamber.Thecorrec t
settingsmustbeusedorerroneousdatawillresult.

Click'OK'








