MMR SB1000 - Page 16


Page|16
41 Daggett Drive, San Jose, CA 95134
Phone: +1 (650) 962 9620 Fax: +1 (650) 962-9647 Email: info@mmr-tech.com Web: www.mmr‐tech.com

GeneralOperation
Seebeck Software Layout

ExperimentView



Beforeselecting 'Start'check thevoltages and temperaturedata (if aK2000 is present), and checkthe
SB1000statusinthe'Experiment Setup'boxtoverifypropercommunication('Ready').Asshownabove,
thevoltagesarecloseto0andequal.Impropermaterialmounting willcauseerroneous
voltages.

If 'Auto Standby'  was selected the 'K2000 Temperature Controller' will first set the Standby
Temperature.

SelectingstartwillbegintheAutomatedDataCollectionprocess.Theprogressandstatuswillbeshown
on the right hand side of the Experiment window. If the experiment is 'Started' before the standby
temperature
is reached, the experiment will wait until the temperature is reached and then begin
automatically.

If a K2000 Temperature Controller is  present, the temperature plot will automatically begin recording
temperaturedata.

