7
This thermostat is designed to switch electric and boiler-based heating systems on
and off on the basis of a set temperature and time.
FUNCTIONS
The thermostat can work in two different modes:
1) Automatic setting: two temperature bands are selected: Comfort and Energy
Saving. The user can choose which of the two temperature bands to select for
each hour of the day. This allows the thermostat to be set once only for the whole
week and to leave it running until it is no longer required.
2) Manual setting: once the temperature bands described above have been set,
simply select the required temperature band when required; this will then be
maintained until a new manual selection is made. Holiday mode, which features an
anti-frost function, can also be set in this manner.
SETTING THE TEMPERATURE BANDS
To get started, the three temperature bands must be set:
1. Press and hold the M button for 3 seconds; the Comfort mode symbol will ap-
pear, along with the default temperature for this mode. Adjust the value using
the + and - buttons.
2. Press the M button again; the Energy Saving mode symbol will appear, along
with the default temperature for this mode. Adjust the value using the + and -
buttons.
3. Press the M button again; the Holiday mode symbol will appear, along with the
default temperature for this mode. Adjust the value using the + and - buttons.
4. Press the M button again to conrm.
The Comfort function is represented by the symbol, and represents the com-
fortable room temperature you wish to reach and maintain.
The Energy Saving function is represented by the symbol and represents the
minimum temperature below which the heating should be turned on in order to
prevent the environment becoming too cold.
The Holiday function is represented by the symbol and is an anti-frost fea-
ture – the temperature is set to the minimum below which the heating should be
turned on to prevent freezing when away from home.
TIME SETTING AND PROGRAMMING
Set the time and day as follows:
1. Press and hold the P button for around 3 seconds. The minutes will start ash-
ing on the display; adjust the value using the + and - buttons.
2. Press the P button again. The hours will start ashing on the display; adjust the
value using the + and - buttons.
3. Press the P button again. The gure corresponding to the day of the week will
start ashing: adjust the value using the + and - buttons. Set 1 for Monday, 2
for Tuesday and so on.
4. Press P again to conrm and set the weekly programming. To set automatic
To Next Page
Loading...