Hot Water Dispenser - English manual 7
EN
Remarks
--Do not touch the boiled water and steam in order to protest against the
scald by the boiled water and hot steam.
-- If the appliance stop to operate with beep sound and the PCB panel
show E7 symbol,means the water is lack, need pour the cool water in
the water tank immediately.
--The appliance can memorize the last operation method anytime
without disconnecting the plug.
--As the appliance has memory function when connecting to plug,
please use about 60 seconds rst in order to obtain desired
temperature water, but it’s memory will be lost after unplug.
--As ambient temperature change everyday, the water volume will
undulate within -15% to +15%.
--The appliance has manual thermostat to recover the heating function
for abnormal operation,if the appliance is no power, stop working,not
boiling the water,wait until the appliance is cool down,you can use
the reset key to press the reset hole (on the front of appliance) several
times under plug out,after that plug in and operate the appliance under
setting temperature of 100C,volume of 000 for one minute until the
detection of boiling point is nished. The appliance is ready for use -
set the Temp and Volume to desired settings.
--After cleaning the appliance, please open the drainage stopper in
order to clean up waste water, please tighten the drainage stopper
after opening it.
Note: If found water leakage from the bottom, please tighten the
drainage stopper.
To Next Page
Loading...
