Hot Water Dispenser - English manual 9
EN
CLEANING AND MAINTENANCES
1.Always switch off and unplug your water dispenser and allow it to
cool completely before cleaning.
2. Do not immerse the appliance into any liquid to avoid the damage.
3. To maintain it’s performance, suggest to descale the appliance
at least once every month. Please use the toxic free detergent such
as citric acid or vinegar, add some citric acid or vinegar in tank,ll
water in tank till max level and operate the appliance under setting of
100C,volume 000 about two or three times, the scale will be get rid of
completely. After the completion, please pour out all the boiled water
and add purge water to operate the appliance once before you drink.
4.Do not use any chemical, metal, wood or abrasive detergent to clean
the appliance housing, always use a damp cloth.
5. Always handle the appliance gently, do not place it near the edge
of the table and the counter, to protect against the deform or function
damage in case it fall down from the table accidently .
ERROR CODE
Display show E7
Problem: Lack of water
Solution: Fill water in tank till max level
Display show E2,E5
Problem: Temperature senser of water inlet has problem
Solution: Send the machine to local after-service center to check or
replace the temperature sensor
Display show E1,E4
Problem: Temperature senser of water outlet has problem
Solution: Send the machine to local after-service center to check or
replace the temperature sensor
No display or non-heating
Problem: Thermostat cut-off
Solution: Use reset key to press the reset hole and recover the machine
Water Leakage
Problem: Drainage stopper is loosen
Solution: Tighten the drainage stopper on the bottom
To Next Page
Loading...