MOA HWD30B - Page 10

10Hot Water Dispenser - English
EN
Problem:
The switch lamp is not
lit after turning on.
Problem:
Appliance is not
operating.
Problem:
Appliance is not
operating efciently.
Problem:
Water is not hot.
Problem:
Water is owing from the
exhaust hole
Possible Cause(s):
Power plug is not
connected into the
power supply.
Possible Cause(s):
- Power plug is not
connected into the
power supply.
- Temporary power
outage.
- Water not added into
the water tank.
- Electronic board
failure.
- Manual reset
temperature control
disconnection.
- Water outlet is
obstructed.
- The water tank oat
has been
disconnected.
Possible Cause(s):
- Machine needs
cleaning & descaling.
- The efuent is not
smooth.
Possible Cause(s):
- Temporary power
outage.
- Heating pipe not
functioning.
- Manual reset
temperature control is
disconnected.
Possible Cause(s):
- The water tank needs
to be descaled.
Solution:
Ensure that the power
plug is plugged into
the power supply.
Solution:
- Connect power plug
into the power supply.
- Power-standby
recovery.
- Inspect water gauge
to ensure that there is
water inside the water
tank.
- Contact the
Customer Service
- Direct reset with the
reset key.
- Descaling required.
Long press the
“VOLUME”key for 3
seconds to descale.
Solution:
- Power-standby
recovery.
- Contact Customer
Service
- Use the reset key for
manual reset.
Solution:
- Power-standby
recovery.
- Contact Customer
Service.
- Use the reset key for
manual reset.
Solution:
- Long press
“VOLUME” key for 3
seconds to descale.
TROUBLESHOOTING