Need help?Do you have a question about the MOBA Farmpacker M100T and is the answer not in the manual?
Defines the machine's safe stopping procedure based on specific conditions and sensor states.
Explains the procedure to initialize the packing lane, allowing the LUST controller to learn stopping positions.
Details how the unlock position is adjusted based on machine speed to ensure accurate egg release.
Provides a guide to interpreting error codes indicated by the unlock unit's run LED for troubleshooting.
Details the four key steps for synchronizing machine timing, covering unlock unit, photocell, and sensor adjustments.
Describes operating modes (FOR, VFC) and explains status/error indications from LUST controller LEDs.
Provides instructions for programming the LUST frequency converter using a programmer module and smartcard.
Describes configurable dipswitch functions and the board's power supply circuits and thermal fuses.
Outlines an emergency procedure to run the farmpacker without a functioning linear actuator using a service mode.
Guides on updating MSW1 software and compares different board versions and update possibilities.
Explains the Inkjet provision, its signals, diagrams, and electrical connections for printing.
Details touch screen calibration, contrast adjustment, and factory reset procedures for optimal performance.
Guides on updating the touch screen software using a special loaderbox unit.
Covers issues like eggs not dropping, incorrect movement, slow speeds, and continuous dropping.
Addresses problems with machine start, lane initialization, and dropset stopping issues.
Details errors related to indicator lights, brakes, clutches, sequence problems, and unlock errors.
General| Brand | MOBA |
|---|---|
| Model | Farmpacker M100T |
| Category | Industrial Equipment |
| Language | English |
To Next Page