1. ASSEMBLY OF ALUMINIUM MASSAGE TABLE
ESENFRITDEPT
CA-01 Massage Table
In order to facilitate the task of mounting your aluminium Table we will detail, the
steps to follow.
Open Up the Legs (The Lower Legs in the original position when
Start Unfolding)
Lay Table on It´s Side and Unfold.
Straighten each Brace.
Release the Buckle.
1
3
2
Position the armrests and check each side of the stretcher before
using it.
9
4
1
Lift the Table Up until all legs are on the Floor.
Loose the side handle, adjust the height and angle of headrest, then press
back the handle.
Insert the bars of headrest into the
holes, put the pillow on the headrest.
Open the Headrest piece.
7
5
6
8
To Next Page
Loading...
